All issues

Search results

I want to know if there is a way of geting the resc files as used in the uboot dash board

Status: Open.

#968 In renode/renode;

· steven11012016 opened on Aug 16, 2026

STM32 EXTI: signal edges are always reported in the falling pending register

Status: Open.

#966 In renode/renode;

· wsawicka-nokia opened on Aug 14, 2026

[nRF52840] Zephyr UART printk console output fails when CONFIG_FLASH and CONFIG_FLASH_MAP are enabled

Status: Open.

#965 In renode/renode;

· auliasadil opened on Aug 13, 2026

STM32G0 DMA: EN bit reads back as 0, and memory-to-peripheral transfers move only the first data unit

Status: Open.

#964 In renode/renode;

· wsawicka-nokia opened on Aug 11, 2026

riscv: obsolete SFENCE.VM encoding is still retired by the RV64 tlib

Status: Open.

#962 In renode/renode;

· carlosqwqqwq opened on Aug 11, 2026

Renode executes scalar M instructions on an RV64 CPU without M

Status: Open.

#961 In renode/renode;

· carlosqwqqwq opened on Aug 11, 2026

Renode executes Zcb instructions when their required extension is absent

Status: Open.

#960 In renode/renode;

· carlosqwqqwq opened on Aug 11, 2026

Zbkb-only CPUs reject all dual-owner Zbb/Zbkb instructions

Status: Open.

#959 In renode/renode;

· carlosqwqqwq opened on Aug 11, 2026

fclass.h ignores NaN-boxing for malformed half operands

Status: Open.

#958 In renode/renode;

· carlosqwqqwq opened on Aug 11, 2026

NRF52_GPIOTE misses edge when pin is idle-high before channel is armed

Status: Open.

#956 In renode/renode;

· alexander-buechel opened on Aug 5, 2026

nRF52840 boot-time reset loop under Renode -- root cause found, already fixed on master (not yet released)

Status: Open.

#954 In renode/renode;

· ashu17706 opened on Jul 31, 2026

Add NXP LS1043A GPIO peripheral support

Status: Open.

#953 In renode/renode;

· MaelaDebrie opened on Jul 30, 2026