Short answer seems to be, yes.
There are sets that are still Openforge 1.0. but if you are new, as I am, you prob are aiming to print all 2.0 pieces. My experience so far is that you can swap the base (magnet & clip piece) with any floor you glue on top. The patterns on the side may not be an exact match, but otherwise, no problems.
Short answer seems to be, yes.
There are sets that are still Openforge 1.0. but if you are new, as I am, you prob are aiming to print all 2.0 pieces. My experience so far is that you can swap the base (magnet & clip piece) with any floor you glue on top. The patterns on the side may not be an exact match, but otherwise, no problems.